2.4GHz 3W Signal Amplifier for Modeling SHRC24G3W
This product uses a special stickers to paste the equipment on the aircraft model, a dedicated power cord, no need to modify can be installed; products using superior metal shell, its good cooling function, so you do not have to worry about the use of the process The device heats up and affects performance. Its superior shielding function, the full protection of your family and your health.
Model: SH- RC24G3W
Frequency range: 2.4-2.5 GHz
Channel width: 20Mhz & 40Mhz
Support standard: IEEE 802.11b / g / n
Operating mode: bi-directional, half-duplex transmission, time division duplex
Connector Type: SMA
Output power: 3000mW (35dBm)
Input power: 0 ~ 20dBm
Transmission gain: 15 - 18dB
Receive gain: ≤ 12 dB
Noise figure: ≤3.5dB
Operating voltage: 5V ~ 16V / 2A DC
Material: aluminum alloy
Product weight: 46g
Product Size: 7.3 x 4 x 1cm
Instructions
Step1: Remove the wireless AP or wireless router on the antenna.
Step2: Take out the SMA cable, connect the wireless AP (wireless router) and signal amplifier (TO Radio ).
Step3: Connect the antenna to the other end of the signal amplifier ( TO Antenna ).
Step4: plug in the power, it is completed.
Write new review
All Categories
- sale
- Arduino
- GPS
- GSM/GPRS
- LCDs
- Single Board Computerv
- Tools
- Development Boards
- Breakout Boards
- Power and Batteries
- Unmanned Aerial System
- Programmers
- Printer
- Tablet
- Intelligent Building
- Electric Vehicle
- Drivers
- Wireless and Communications
- Robotics
- Tracking
- solar Cell
-
Sensors
- IMU/AHRS
- PIR
- Ultrasonics
- Biometrics
- Touch
- liquid level sensor
- Radiations
- Current/Voltage
- Proximity Sensor
- Temperature
- Humidity
- Inclinometer
- Gyro
- Accelerometers
- Flame
- Sound
- Pressure
- Flow Meter
- GAS
- Laser
- Infrared
- Mocrowave
- Magnet & Compass
- Light / image / Color
- Vibration/Force/Torque/Flex
- anemometer
- ID
- Sound
- Components
- Cables
- Interface Converter
- LED and Lighting
Related Articles
There is no article related to this product.
