2.4GHz 4W Signal Amplifier for Modeling SH24Gi4000
This product two-chip and the use of superior technology of the metal shell, its good cooling function, so you do not have to worry about the use of equipment heating and affect performance.Its superior shielding function, the full protection of your family and your health.
Model: SH24Gi4000
Frequency range: 2.4-2.5 GHz
Channel width: 20Mhz & 40Mhz
Support standard: IEEE 802.11b / g / n
Operating mode: bi-directional, half-duplex transmission, time division duplex
Connector Type: SMA
Output power: 4000mW (36dBm)
Input power: 0 ~ 20dBm
Transmission gain: 16 - 19dB
Receive gain: ≤ 15 dB
Noise figure: ≤3.5dB
Operating voltage: 6V / 2A DC, 100 ~ 240V
Material: aluminum alloy
Product Weight: 145g Product Size: 10 * 8.6 * 2.1cm
Gross Weight: 380g Packaging Size: 21 * 15 * 6cm
Instructions
Step1: Remove the wireless AP or wireless router on the antenna.
Step2: Take out the SMA cable, connect the wireless AP (wireless router) and signal amplifier (TO Radio ).
Step3: Connect the antenna to the other end of the signal amplifier ( TO Antenna ).
Step4: plug in the power, it is completed.
Write new review
All Categories
- sale
- Arduino
- GPS
- GSM/GPRS
- LCDs
- Single Board Computerv
- Tools
- Development Boards
- Breakout Boards
- Power and Batteries
- Unmanned Aerial System
- Programmers
- Printer
- Tablet
- Intelligent Building
- Electric Vehicle
- Drivers
- Wireless and Communications
- Robotics
- Tracking
- solar Cell
-
Sensors
- IMU/AHRS
- PIR
- Ultrasonics
- Biometrics
- Touch
- liquid level sensor
- Radiations
- Current/Voltage
- Proximity Sensor
- Temperature
- Humidity
- Inclinometer
- Gyro
- Accelerometers
- Flame
- Sound
- Pressure
- Flow Meter
- GAS
- Laser
- Infrared
- Mocrowave
- Magnet & Compass
- Light / image / Color
- Vibration/Force/Torque/Flex
- anemometer
- ID
- Sound
- Components
- Cables
- Interface Converter
- LED and Lighting
Related Articles
There is no article related to this product.
